![]() ![]() ğor instructions on calibration using Logger Pro computer software, see.Click Done to complete the calibration process.Once saved, this new calibration will be used automatically, regardless of the interface to which the sensor is connected. Go to the Storage tab and click the Set Sensor Calibration button (Logger Pro) or Save Calibration to Sensor (LabQuest).You can also store your custom calibration on the sensor using the following steps: If your sample water has a salinity greater than 1000 mg/L, the saturated dissolved oxygen value will need to be calculated.If these tables do not extend to your elevation, see for more information. If you do not know the current air pressure, use Table 2 to estimate the air pressure at your altitude.When the displayed voltage reading stabilizes, enter the saturated dissolved oxygen value (in mg/L) from Table 1 using the current air pressure and temperature values.Important: Do not touch the membrane or get it wet during this step. ![]() Add water to the bottle to a depth of about 1 cm and screw the bottle into the cap, as shown.Slide the lid 1–2 cm onto the probe body. Remove the lid from the empty calibration bottle provided with the probe. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |